Powerplus POWXG3023 BRUSH CUTTER 51,7CC EN User Manual download pdf (Page 7)

POWXG3012+XG3023

P a g e | 7

www.varo.com

8.4 Installation of the spool

Push the rear flange onto the tool head, and

draw the spool taut.

Block the tool head in the same way as

described above. Wind the spool tightly.

9 FUEL AND LUBRICATION

9.1 Fuel

Use regular grade unleaded petrol mixed with 40:1 custom 2-cycle engine oil for best results.

Use mixing ratios in Section FUEL MIXING TABLE below.

WARNING: Never use normal petrol in your unit. This will cause permanent

engine damage and void the manufacturer’s warranty for the product. Never

use a fuel mixture that has been stored for over 90 days.

WARNING: 2-cycle lubricant must be a premium grade oil for 2-cycle air

cooled engines mixed at a 40:1 ratio. Do not use any 2-cycle oil product with a

recommended mixing ratio of 100:1. If insufficient lubrication is the cause of

engine damage, it voids the manufacturer’s engine warranty.

9.2 Mixing fuel

Add oil to an approved fuel container followed by the petrol to allow incoming petrol to mix with

oil. Shake container to ensure thorough mix.

WARNING: Lack of lubrication voids engine warranty. Petrol and oil must be

mixed at 40:1.

9.2.1 Fuel and lubrication symbols

9.2.2 Reccomanded fuels

Some conventional kinds of petrol are now blended with oxygenates such as alcohol or an

ether compound to meet clean air standards. The engine is designed to operate satisfactorily

with any petrol intended for automotive use including oxygenated petrol.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Powerplus POWXG3023 BRUSH CUTTER 51,7CC EN User Manual Page 7