Powerplus POWX093 Service Manual download pdf (Page 6)

POWX093 EN

 Ensure that milling cutter is firmly clamped.

 Use only milling cutters for routers; never use e.g. milling cutters for drilling machines or

stationary machines.

 Use only commercially available milling cutters for routers with a shank diameter 6 mm or

8 mm.

 Always use both hands to guide the tool.

 Never wedge the ON switch fast.

 Never reach into the milling zone while the tool is running.

 Feed only running milling cutters to the material.

 Note direction of cut - always move the cutter against the material.

 When work is finished, remove the milling cutter from the tool.

 Wood dust set up during work is harmful to health. Always work with dust collector

operating.

 Wear protective goggles, ear protectors and, if necessary, breathing mask.

 Observe general safety regulations for handling and using electric tools..

7 OPERATION

7.1 Depth Stop

Locate the depth stop on the left-hand side of the cutting machine. This continuously

adjustable stop is intended to limit the depth of the cut. Locate the fixing screw for the depth

stop (1). Loosen it by turning it in anticlockwise direction. To move the depth stop up or down,

turn the stop adjuster in clockwise or anticlockwise direction (2).

7.2 Locking lever for cutting machine body

When viewed from the front, the locking lever (3) is located at the rear on the left-hand side.

The cutting machine body is spring-tensioned. Take care when releasing the locking lever.

Grasp both handles and brace yourself before releasing the lever (4). Press downwards to

allow the cutting machine body to move down. When you reduce the downward pressure, the

springs force the cutting machine body back up into its highest position.

CAUTION: The housing of the machine is under spring tension. When you release the locking

lever, it returns to its highest position..

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Powerplus POWX093 Service Manual Page 6