Powerplus POWX0460 Service Manual download pdf (Page 5)

POWX0460 EN

7 OPERATION

Do not sand plaster surfaces, (WARNING: In this case your guarantee

becomes void) this may clog the motor (brushes, ball bearings, ..).

7.1 Switching Onoff

 To switch the tool on, press the on/off switch.

 To switch the tool off, release the on/off switch.

7.2 Continuous operation / ON/OFF lock button

to switch on :

 Hold the on/off switch pressed

 Press the lock button

 release the on/off switch

to switch off :

press the on/off switch once to release the lockon button

7.3 Speed adjusting dial

Your POW X0460 is equipped with a variable speed selector .

You can turn the speed selector switch from 1 to 6 to set the desired belt speed.

7.4 Mounting a sanding belt

 Pull out the locking lever in the side of the belt sander to loosen the sanding belt

 Take a sanding belt of the required grain size and place it on the rollers. Make sure that

the arrow on the inside of the sanding belt points in the same direction as the arrow on the

machine.

 Make sure that the sanding belt is straight and centered on the rollers.

 Push the clamping lever back.

 Switch the machine on to let the sanding belt run. With the machine switched on, turn the

adjusting screw until the sanding belt keeps running straight.

The sanding belt must be fitted firmly on the sanding pad and should not

come loose.

7.5 Collecting the dust

dust box :

Push and slide the dust collection box into the connector for dust collection. Make sure the

grooves on the right and left of the connector are into place and it is secured before starting

the operation..

7.6 Auxiliary handle position adjustment

Pull out the lock on the right of the handle and rotate in desired position. Put the lock back in

place by pushing towards handle.

1 2 3 4 5 6 7 8

No comments

Powerplus POWX0460 Service Manual Page 5