Powerplus POW30540 Service Manual download pdf (Page 4)

POW30540

5.4 Power tool use and care

Do not expect the power tool to do more than it can. Use the correct power tool for what

you want to do. A power tool will achieve better results and be

safer if used in the context

for which it was designed.

Do not use the power tool if the switch cannot turn it on and off. A power tool with a

broken switch is dangerous and must be repaired.

§ Disconnect the plug from the power source before making adjustm

ents, changing

accessories, or storing power tools. Such preventive safety measures reduce the risk of

starting the power tool accidentally.

Store power tools, when not in use, out of the reach of children and do not allow people

who are not familiar with

the power tool or these instructions to operate it. Power tools are

potentially dangerous in the hands of untrained users.

Maintain power tools. Check for misalignment or jammed moving parts, breakages or any

other feature that might affect the operation o

f the power tool. If it is damaged, the power

tool must be repaired. Many accidents are caused by using poorly maintained power

tools.

Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting

edges are less likely to jam and are easier to control.

Use the power tool, accessories and cutting tools, etc., in accordance with these

instructions and in the manner intended for the particular type of power tool, taking into

account the working conditions and the work which needs to

be done. Using a power tool

in ways for which it was not intended can lead to potentially hazardous situations.

5.5 Service

Your power tool should be serviced by a qualified specialist using only standard spare

parts. This will ensure that it meets the required safety standards.

6 MACHINE-SPECIFIC SAFETY WARNINGS

§ Use appropriate detectors to determine if

utility lines are hidden in the work area or

the local utility company for assistance.

§ Switch off the power tool immediately when the tool insert jams. Be

prepared for high

reaction torque that can cause kickback.

§ Hold power tool by the insulated gripping

surfaces, when performing an operation

the cutting tool may run into hidden wiring.

§ When working with the machine, always hold it firmly with both h

ands and provide

secure stance.

§ Secure the work piece.

§ Keep your workplace clean.

§ Always wait until the machine has come to a

complete stop before placing it down.

§ Before any work on the machine (e. g., maintenance,

tool change, etc.) as well as

transport and storage, set the rotational direction

switch to the centre position.

7 FEATURES

7.1 Keyless chuck

Your drill has a keyless chuck that allows you to hand tighten or release drill bit in the chuck

jaws.

The SDS-Plus tool holder allows for si

mple and convenient changing of

drilling tools without the use of additional tools.

www.varo.com