Powerplus POWX0910 Manual download pdf (Page 7)

POWX0910 EN

7.1.2 Removing a cutter

 Press and hold down the spindle lock button (5) and loosen the collet nut (6) completely.

 Remove the cutter.

 Fit a new suitable accessory and tighten the collet nut.

Note: Never tighten the collet nut without a cutter in the collet.

7.2 Depth adjustment (Fig. 2)

Locate the depth stop (4) on the left-hand side of the cutting machine. This continuously

adjustable stop is intended to limit the depth of the cut. Loosen it by turning it in anticlockwise

direction. To move the depth stop up or down to the desired depth according to the marker of

the scale label (3).

NOTE: Make sure the locking knob (10) is fixed firmly when operating this

machine.

7.3 Locking lever (13) for cutting machine body

When viewed from the front, the locking lever is located at the rear on the left-hand side. The

cutting machine body is spring-tensioned. Take care when releasing the locking lever. Grasp

both handles and brace yourself before releasing the lever. Press downwards to allow the

cutting machine body to move down. When you reduce the downward pressure, the springs

force the cutting machine body back up into its highest position.

The released position (a) or lock position (b) of locking lever as shown in Fig. 3.

CAUTION: The housing of the machine is under spring tension. When you

release the locking lever, it returns to its highest position.

7.4 Mounting and adjusting the parallel guide (Fig. 4)

 The parallel guide can be used for cutting parallel to the edge of the work-piece.

 Fit the guide rods (a) to the frame using the screws (b).

 Release the two lock knobs securing the parallel guide and push them in so that the guide

is at the desired distance from the cutter head.

 Tighten the two lock knobs.

 Press the guide securely against the edge of the work-piece and execute the cut.

CAUTION: Abnormal vibrations may be due to a blunt cutter head.

7.5 Fitting the centre point (Fig. 5)

The centre point is used for routing circles.

 Remove a guide rod (a) from the parallel guide.

 Mount the centre point (b) to the guide rod.

 Slide the guide rod in the router base plate and tighten the lock knobs.

 Position the tip of centre point at the centre of your circle.

 Press it slightly so that the tip is firmly in the wood. You can now cut the circle.

7.6 Dust extraction outlet (Fig. 6)

It is advised to use the dust extraction outlet. You can purchase a suitable

commercial vacuum cleaner or extract the dust via an extractor tube while

1 2 3 4 5 6 7 8 9 10 11

No comments

Powerplus POWX0910 Manual Page 7